Technical drawing
Dispenser · AiFO
Lid dispenser O95-114 mm DZ-L2400C
Item no. DZ-L2400C · EAN 2010000070291
- made of impact-resistant plastic
- for flat lids
- for vertical or horizontal mounting
- lid diameter
- Ø95-114 mm
- mounting hole
- Ø146 mm
In brief
- Lids Ø95–114 mm, mounting hole Ø146 mm.
- The range starts where the DZ-L2200C model ends.
- A design for flat versions only, body in impact-resistant plastic.
- A cut-out 22 mm larger than in the smaller variant.
Prices and stock levels are in the B2B shop. Versions for non-standard vessels are quoted individually.
Lid dispenser O95-114 mm DZ-L2400C – how to choose the right one
DZ-L2400C is a dispenser for flat lids 95–114 mm in diameter, set in a Ø146 mm opening. The impact-resistant plastic body is fitted in the worktop or in the vertical panel of the fit-out.
This version takes larger lids, in the 95–114 mm range, which the smaller DZ-L2200C model no longer handles. In venues with a wide menu, both versions are usually installed side by side.
With two dispensers in one counter, not only the diameter counts but also the spacing of the cut-outs. Openings of Ø124 and Ø146 mm together take up a considerable stretch, and material must remain between them for a load-bearing strip.
How to choose a dispenser for the vessel diameter and the worktop – we explained it in the selection guide for this category.
Where it works
- Outlets serving large cups for cold drinks
- Positions with two dispensers for different sizes
- Milk bars and catering outlets in shopping centres
- Fit-out fronts where the guest takes the lid himself
FAQ
Frequently asked questions
Have not found your answer? Give the vessel diameter and the type of mounting – we will select the dispenser.
Ask a questionWhich model should be chosen for 400 ml cups?
The measured lid diameter is decisive: 95–114 mm calls for this model, 70–95 mm for the smaller DZ-L2200C. The declared cup volume alone does not determine the choice.
Can Ø146 mm be made in an existing Ø124 mm opening?
It can be bored out with a hole saw, but it must be checked how much material will remain at the edge. With a narrow working strip it is safer to move the dispenser to a new place.
Enquiry
We will quote Lid dispenser O95-114 mm DZ-L2400C for your appliance
Give the vessel diameter and how it is to be set into the worktop – we will reply with a selection and a quote.
B2B shopGet in touch
We usually reply within 24 working hours.