Technical drawing
Sink mixer taps · AiFO
Two-hole mixer tap (spout L=250 mm, 1/2") AG-BD25
Item no. AG-BD25 · EAN 2010000118009
- self-lubricating, non-seizing valve cartridges
- chrome-plated steel knobs
- swivel spout
- water flow from 32l/min to 38l/min at a pressure of 3 to 5 bar
In brief
- A 250 mm spout, the middle length among the two-hole versions.
- Two chrome-plated handles, self-lubricating heads, a swivel spout.
- 1/2 inch connection, outflow in the range 32–38 l/min.
- The spacing of the mounting holes is measured on site before ordering.
Prices and stock levels are in the B2B shop. When fitting out a whole back-of-house we quote the complete set.
Two-hole mixer tap (spout L=250 mm, 1/2") AG-BD25 – how to choose the right one
AG-BD25 is a two-hole mixer tap with a spout 250 mm long and a half-inch connection. The water is controlled with two steel handles, and the outflow is from 32 to 38 litres per minute at a pressure of 3–5 bar.
A quarter-metre spout is a length that, on a typical catering sink, directs the stream roughly to the middle of the bowl. This version sits between the shortest variant (200 mm) and the model with a full 300 mm.
When replacing a tap in a finished worktop, the centre-to-centre spacing between the holes has to be measured on site and confirmed before ordering, because it decides whether the tap will seat at all.
How to match the tap to the station, the connection and the flow required – we explained it in the selection guide for this category.
Where it works
- Typical catering sinks with a standard bowl
- Replacing a two-hole tap in an existing worktop
- Dishwashing areas with separate hot and cold water supplies
- Container filling stations on a half-inch installation
FAQ
Frequently asked questions
Have not found your answer? Give the station, the connection and what it is for – we will select the tapware.
Ask a questionWhat hole spacing does this tap have?
Before ordering for a finished worktop, the distance between the centres of the existing holes has to be measured and compatibility confirmed with an AiFO adviser – otherwise we risk buying something that cannot be installed.
Is 32–38 l/min enough for filling kettles?
For pots and GN containers it is fully sufficient. For fast filling of large vessels, the category includes AG-P30x pillar mixers with a flow of 92–104 l/min, but they have a 3/4" connection and a Ø46 mm mounting hole.
Enquiry
We will quote Two-hole mixer tap (spout L=250 mm, 1/2") AG-BD25 for your appliance
Give the mounting, the connection and what the station is for – we will reply with a selection and a quote.
B2B shopGet in touch
We usually reply within 24 working hours.