Technical drawing
Sink mixer taps · AiFO
Mixer tap (spout L=250 mm, 3/8") AG-MS925
Item no. AG-MS925 · EAN 2010000073643
- ceramic cartridges
- chrome-plated steel knobs
- swivel spout
- water flow from 30 l/min to 36 l/min at a pressure of 3 to 5 bar
- mounting hole Ø35 mm
In brief
- The middle spout length in the ceramic series: 250 mm.
- Two chrome-plated steel handles and a swivel spout.
- 3/8 inch connection, mounting in a Ø35 mm hole.
- The manufacturer states a flow rate of 30–36 l/min at 3–5 bar.
Prices and stock levels are in the B2B shop. When fitting out a whole back-of-house we quote the complete set.
Mixer tap (spout L=250 mm, 3/8") AG-MS925 – how to choose the right one
AG-MS925 is a mixer tap with a 250 mm spout, ceramic heads and two chrome-plated handles. It works on a 3/8 inch connection, is mounted in a Ø35 mm hole, and the flow rate is given in the range 30–36 l/min.
A quarter of a metre of outlet with a single mounting hole is a configuration for an average catering sink. It requires no preparation of the worktop other than for a typical single-lever tap, and it gives separate control of both streams.
The choice between this model and its twin from the MFBS range comes down to the heads. Here they are ceramic, there self-lubricating, and with an identical spout length and an identical flow rate that is the only difference the data shows.
How to match the tap to the station, the connection and the flow required – we explained it in the selection guide for this category.
Where it works
- Standard single-bowl sinks in a staff canteen kitchen
- Replacing a single-lever tap with a two-valve one
- Wash-up stations where vessels are filled regularly
- Back-of-house areas standardising servicing on ceramic cartridges
FAQ
Frequently asked questions
Have not found your answer? Give the station, the connection and what it is for – we will select the tapware.
Ask a questionCeramic or self-lubricating heads at the same dimension?
Ceramic cartridges are easier to source and run smoothly from the first turn. The manufacturer recommends the self-lubricating solution where a valve stands unused for weeks and could seize.
Do two knobs mean two holes are needed?
Not on this model. The whole tap sits on a single base in a hole thirty-five millimetres across, so preparing the worktop looks exactly as it does for an ordinary lever tap.
Enquiry
We will quote Mixer tap (spout L=250 mm, 3/8") AG-MS925 for your appliance
Give the mounting, the connection and what the station is for – we will reply with a selection and a quote.
B2B shopGet in touch
We usually reply within 24 working hours.