Technical drawing
Condensate drain · AiFO
Drip tray (324x220x25 mm) KP-BDD5
Item no. KP-BDD5 · EAN 2010000171080
- made by rotational moulding
- Material
- polyethylene
- max. operating temperature
- 80°C
In brief
- A 324 x 220 x 25 mm tray - the shortest item in the BDD family, but 220 mm wide.
- The material is polyethylene rated for use up to 80°C.
- The 25 mm high side fits under the coil block without raising the whole fit-out.
- The 324 x 220 mm proportions suit evaporators that are short but built deep.
Prices and stock levels are in the B2B shop. Honeycomb panels are cut to size, non-standard parts are quoted individually.
Drip tray (324x220x25 mm) KP-BDD5 – how to choose the right one
The KP-BDD5 drip tray, measuring 324 x 220 x 25 mm, is a polyethylene under-evaporator tray resistant to temperatures up to 80°C. It catches condensate running off the fins and channels it towards the drain in the furniture's base.
This item's footprint is unusual: at only 324 mm long, it is as much as 220 mm wide, a shape closer to a square than a narrow strip. This outline suits evaporators mounted across the chamber, where condensate collects over a large area rather than along a single line.
When fitting it, the layout matters more than the dimension alone. The tray must slope towards the drain stub - levelled flat, it holds water in the corners, and during defrosting that water runs back onto the fins instead of leaving through the installation.
How to match a drain to the hole and a honeycomb to the cabinet – we explained it in the selection guide for this category.
Where it works
- Cross-mounted evaporators in refrigerated cabinets with a narrow chamber
- Fit-outs where under 30 mm of clearance is left under the coil block
- Replacing a deformed tray after years of defrost cycles
- Units with heater-based defrosting, where the plastic can get warmed
FAQ
Frequently asked questions
Have not found your answer? Give the hole diameter and the thread – we will select the drain and the trap.
Ask a questionIs 220 mm of width a lot for an under-evaporator tray?
Yes, it is one of the widest items in this group. Narrow 60-115 mm profiles collect water from a single row of fins, while 220 mm covers a block with several rows of tubes.
What does the 80°C use temperature mean for a refrigeration part?
It is not about chamber operating conditions, but about defrosting. The heater warms the area around the coil block, and it is this cycle, not the cold, that sets the upper limit for the plastic.
How do I check whether this tray will fit my unit?
Measure the gap between the bottom edge of the fins and the base of the pan, and the outline of the block itself. The 25 mm height needs to fit within the gap, and the 324 x 220 mm footprint must not clash with the evaporator's mounting.
Enquiry
We will quote Drip tray (324x220x25 mm) KP-BDD5 for your appliance
Give the hole diameter, the thread or the dimensions of the cabinet – we will reply with a selection and a quote.
B2B shopGet in touch
We usually reply within 24 working hours.