Technical drawing
Condensate evaporation tray · AiFO
Condensate evaporation tray KP-BCPT1N – 300x222x36.5 mm
Item no. KP-BCPT1N · EAN 2010000117408
- made of polymers
- vertical tray
- version with a heater hole KP-BCPT1
- Material
- polycarbonate
- capacity
- 1,65 l
In brief
- KP-BCPT1N is the closed variant of the flat 300 × 222 × 36.5 mm tray with a capacity of 1.65 l – without the heater opening.
- A polymer body, vertical variant, footprint identical to KP-BCPT1.
- No heater passage means one fewer potential point of leakage.
- Installation comes down to sliding the tray into place – without connecting anything.
Prices and stock levels are in the B2B shop. Thermoformed made-to-measure parts are quoted individually – a drawing or the installation dimensions is enough.
Condensate evaporation tray without an opening (300x222x36.5 mm) KP-BCPT1N – how to choose the right one
KP-BCPT1N is a polymer condensate evaporation tray measuring 300 × 222 × 36.5 mm with a capacity of 1.65 l, made without the heater opening. It is the same body as KP-BCPT1, intended to work purely on passive evaporation.
The heater passage through the tank wall is a point where a leak can occur, as the seal works submerged and through heating cycles. Where there will be no heater anyway, a one-piece moulding eliminates this point and simplifies installation in the condensing unit compartment.
Where to start: installation height, capacity, heater – we explained it in the selection guide for this category.
Where it works
- Installations where condensate is emptied during servicing
- Installations with a clearance of around 4 cm and passive evaporation
- Tanks emptied by hand as part of periodic servicing
- Installations where additional electrical components aren't permitted in the condensing unit compartment
FAQ
Frequently asked questions
Have not found your answer? Give the installation dimensions and the amount of condensate – we will select the tray and the heater.
Ask a questionCan an opening for a heater be drilled into KP-BCPT1N on site?
It's not worth it. The opening not only has to be made, but sealed so that it withstands permanent submersion and cyclical heating; in series production this is done in the mould, not with a drill on site. The version with a factory heater passage is KP-BCPT1, with an identical 300 × 222 × 36.5 mm footprint and the same 1.65 l capacity.
How often does a tray without a heater need emptying?
This depends on the condensate build-up in the specific unit, not on the tray model. A practical method: after start-up, check the water level after a day of full load and calculate how many days 1.65 l lasts. If it comes out shorter than the interval between services, condensate needs to be drained away from the unit, or a version with a heater is needed.
Enquiry
We will quote Condensate evaporation tray without an opening (300x222x36.5 mm) KP-BCPT1N for your appliance
Give the dimensions of the space available and the amount of condensate – we will reply with a selection and a quote.
B2B shopGet in touch
We usually reply within 24 working hours.