Technical drawing
Condensate tray · AiFO
Condensate pan KP-1240 – 1240x460x20 mm
Item no. KP-1240 · EAN 2010000061466
- made of polyethylene
- Material
- polyethylene
In brief
- KP-1240 is a pan 1240 × 460 mm with a wall height of 20 mm – an evaporation surface of close to 0.57 m².
- Made of polyethylene: light, does not corrode, stands up to washing.
- It works as a catch element under the full width of the appliance, not as a tank in the compressor compartment.
- The 20 mm wall leaves no reserve for water, so the pan must stand level.
Prices and stock levels are in the B2B shop. Thermoformed made-to-measure parts are quoted individually – a drawing or the installation dimensions is enough.
Condensate tray (1240x460x20 mm) KP-1240 – how to choose the right one
KP-1240 is a polyethylene condensate tray measuring 1240 × 460 × 20 mm. It is a different type of solution from a container: the aim is not to collect water at one point but to catch it across the full width of the appliance and expose it for evaporation over an area of almost 0.57 m² – several times larger than the footprint of the KP-BCPT evaporation containers.
The large surface area promotes evaporation without a heater, but the 20 mm wall height leaves no reserve. The tray must stand level and must not receive water faster than it evaporates. It works where condensate runs off in a thin layer from a large area; for a concentrated outflow from the evaporator, a container with a heater is more suitable.
Where to start: installation height, capacity, heater – we explained it in the selection guide for this category.
Where it works
- Catching condensate under the full width of a refrigerated shelving unit or display case
- Protecting the floor under appliances set up in a line
- Inspections and servicing – catching the water when defrosting a cold room
- Low-temperature appliances where the water runs off along the whole length
FAQ
Frequently asked questions
Have not found your answer? Give the installation dimensions and the amount of condensate – we will select the tray and the heater.
Ask a questionCan the pan be fitted with a heater?
It is not designed for one: the 20 mm wall does not provide a water column in which a heater could work submerged. If evaporation is to be assisted, choose a container designed for a heater – for example KP-BCPT2, 41 mm high, which can take two PTC heaters.
How much water does the pan hold?
Geometrically, with a 1240 × 460 mm footprint and a 20 mm wall, that comes to over 11 l, but it is a theoretical figure. In practice the pan is not filled to the rim – at this height a slight fall in the floor is enough for the water to run out over the side. The real reserve is a layer a few millimetres deep, that is a few litres.
Can a pan be ordered in other dimensions?
Yes. We thermoform non-standard items to the customer's drawing, up to 2 m long – they are ordered as item KP-JDA. A quotation requires a dimensioned drawing, the material specified and the expected batch size, because the cost of the mould is spread over the pieces. The solution therefore makes sense for production runs, not for a single item.
Enquiry
We will quote Condensate tray (1240x460x20 mm) KP-1240 for your appliance
Give the dimensions of the space available and the amount of condensate – we will reply with a selection and a quote.
B2B shopGet in touch
We usually reply within 24 working hours.